|
MATERIAL: Metallized Polypropylene capacitors
in non-inductive construction.
LEADS: Tinned Copper soldered to capacitor with
63-37 Sn-Pb
TEMPERATURE RANGE: May be operated at rated voltage
from -55°C to + 85°C. Voltage must be de-rated linearly
to 60% between +85°C to +105°C.
ELECTRICAL [NON-DESTRUCTIVE] TESTS:
-
Capacitance shall be measured at 1 KHz. ± 20 Hz and
+ 25°C for values up to 1.0 MFD. Values greater than
1.0 MFD. shall be measured at 120 Hz. ± 10 Hz.
Ref: MIL-STD-202E, method 305.
-
Dissipation Factor shall be measured as described
for capacitance and shall not exceed 0.2%.
-
Insulation Resistance shall be measured at rated
voltage. After 2 minutes under voltage, minimum values
shall be 200,000 MEG/MFD., need not exceed 400,000
megohms.
Ref: MIL-STD-202E, method 302.
-
Dielectric Strength: Capacitors shall withstand specified
DC test potential for 60 seconds through a limiting
resistance of 1 ohm/volt. Terminal to terminal will
be 150% of rated voltage. TerminaI to case will be
200 % of rated voltage..
Ref: MIL-STD-202E, method 301.
-
Dielectric Absorption shall not exceed 0.1% when
tested to MIL-C-19978D.
Ref: MIL-C-19978D, paragraph 3.22.
|
