Click on image for larger image

SPECIFICATIONS:

1. CAPACITY: TABULATED, MEASURED AT 1KHz AND 25°C.
2. TOLERANCE: SHALL BE INDICATED BY ONE OF THE FOLLOWINGING SUFFIXS; NONE ±20%, K ± 10%, J ± 5%, H±3%, G±2% AND TOLERANCE, OTHER THAN SHOWN ABOVE REFER TO FACTORY.
3. RATED WORKING VOLTAGE: TABULATED.
4. DISSIPATION FACTOR: LESS THAN 0.2% AT 1KHz AND 25°C
5. INSULATION RESISTANCE: SHALL EXCEED 200,000 MEG/MFD., AFTER TWO MINUTE CHARGE AT THE RATED VOLATAGE AND 25°C., NEED NOT EXCEED 400,000 MEGOHMS.
6. DIELECTRIC STRENGTH: SHALL WITHSTAND A SURGE OF 150% OF THE RATED VOLTAGE FOR ONE MINUTE THRU A LIMITING RESISTANCE OF 1 OHM PER VOLT.
7. TEMPERATURE RANGE: -55°C TO 85°C AT FULL RATING, DERATE TO 60% AT 105°C
8. CASE: PRE-MOLDED PLASTIC CASE WITH EPOXY POTTING.
9. LEAD MATERIAL: TINNED COPPERWELD WIRE.
10. MARKING: COPPERWELD, WIRE, TINNED, IS STANDARD.

Attention: This specification is preliminary nature. The information, contained herein, was obtained thru limited initial testing and may require adjustment over extended time. IMB reserves the right to adjustments. Should they become necessary, or present and future testing.