|
Click on image for larger image
|
GENERAL SPECIFICATIONS:
- CAPACITY: TABULATED
- TOLERANCE: SHALL BE INDICATED BY ONE OF THE FOLLOWINGING
SUFFIXS; NONE ±20%, K ± 10%, J ± 5%, H±3%, G±2%, AND
F ± 1%.
- RATED WORKING VOLTAGE: TABULATED.
- DISSIPATION FACTOR: LESS THAN 0.1% AT 1KHz AND 25°C
- INSULATION RESISTANCE: SHALL EXCEED 250,000 MEG/MFD.,
AFTER TWO MINUTE CHARGE AT THE RATED VOLATAGE AND 25°C.,
NEED NOT EXCEED 500,000 MEGOHMS.
- DIELECTRIC STRENGTH: SHALL WITHSTAND A SURGE OF 200%
OF THE RATED VOLTAGE FOR ONE MINUTE AT 25°C. THRU A
LIMITING RESISTANCE OF 1 OHM PER VOLT.
- TEMPERATURE RANGE: -55°C TO 85°C.
- CASE: POLYESTER PRESSURE TAPE WITH EPOXY ENDFILLS.
- LEAD MATERIAL: TINNED COPPERWELD WIRE.
THIS SPECIFICATION IS PRELIMINARY
ONLY AND IMB RESERVES THE RIGHT TO ADJUST SPECIFIC DIMENSIONAL
NOMINALS IF REQUIRED BY PRODUCTION RESULTS. THIS WOULD
APPLY TO THE
"L" AND "D" DIMENSIONS, PRIMARILY.
 
|
