POLYESTER CAPACITORS MYLAR AND
FOIL CAPACITORS - AXIAL LEADS WRAP AND FILL
Click on image for larger image
SPECIFICATIONS:
CAPACITY: TABULATED
TOLERANCE: SHALL BE INDICATED BY ONE OF THE FOLLOWING
SUFFIXS; NONE ±20%, K ± 10%, J ± 5%, G ± 2%, AND F ±
1%.
RATED WORKING VOLTAGE: TABULATED.
DISSIPATION FACTOR: LESS THAN 0.5% AT 1KHz AND 25°C
INSULATION RESISTANCE: SHALL EXCEED 50,000 MEG/MFD.,
AFTER TWO MINUTE CHARGE AT THE RATED VOLATAGE AND 25°C.,
NEED NOT EXCEED 100,000 MEGOHMS.
DIELECTRIC STRENGTH: SHALL WITHSTAND A SURGE OF 150%
OF THE RATED VOLTAGE FOR ONE MINUTE THRU A LIMITING
RESISTANCE OF 1 - 5 OHMS PER VOLT.
TEMPERATURE RANGE: -55°C TO 85°C. DERATE 50% AT +125°C.
CASE: POLYESTER PRESSURE TAPE WITH EPOXY ENDFILLS.
LEAD MATERIAL: TINNED COPPERWELD WIRE.
MARKING: STANDARD COMMERCIAL PRACTICE.
WIRE
LEADS
PART LENGTH
A.W.G.
DIA.
.58 THRU .71
.84 THRU . 1.25
1.50 THRU 2.25
#24
#22
#20
.020
.025
.032
THIS SPECIFICATION IS PRELIMINARY
ONLY AND IMB RESERVES THE RIGHT TO ADJUST SPECIFIC
DIMENSIONAL NOMINALS IF REQUIRED BY PRODUCTION RESULTS.
THIS WOULD APPLY TO THE DIAMETER DIMENSION ONLY.
