Click on image for larger image

SPECIFICATIONS:

1. CAPACITY: TABULATED
2. TOLERANCE: SHALL BE INDICATED BY ONE OF THE FOLLOWINGING SUFFIXS; NONE ±20%, K ± 10%, J ± 5%, H±3%, G±2%, AND F ± 1%.
3. WORKING VOLTAGE: 50V and 100V.
4. DISSIPATION FACTOR: LESS THAN 0.2% AT 1KHz AND 25°C
5. INSULATION RESISTANCE: SHALL EXCEED 250,000 MEG/MFD., AFTER TWO MINUTE CHARGE AT THE RATED VOLTAGE AND 25°C., NEED NOT EXCEED 400,000 MEGOHMS.
6. DIELECTRIC STRENGTH: SHALL WITHSTAND A SURGE OF 150% OF THE RATED VOLTAGE FOR ONE MINUTE THRU A LIMITING RESISTANCE OF 1 OHM PER VOLT.
7. TEMPERATURE RANGE: -55°C TO +85°C AT FULL RATING TO 105°C DERATE 50%.
8. LEAD MATERIAL: TINNED COPPERWELD WIRE.
9. CASE MATERIAL/STYLE ARE AS FOLLOWS:
   UA2B - Polyester pressure tape wrap with epoxy endfills and of a pressed oval configuration and axial leads
   UA1B - Polyester pressure tape wrap with epoxy endfills and of a cylindrical configuration and axial leads.
   UV2B - Pre-molded epoxy case with epoxy potting material of a rectangular configuration and axial lead.
   UP2B - Pre-molded epoxy case with epoxy potting material of a rectangular configuration and radial lead.
   UL1B - Tinned brass tube with glass to metal endseals and axial leads. This type is hermetically sealed.

* CONSULT FACTORY FOR TOLERANCE ±1% thru 3% ON STYLE UA2B, UV2B, AND UP2B.THIS SPECIFICATION IS ISSUED AS PRELIMINARY ONLY AND THE DIMENSIONS ARE SUBJECT TO SLIGHT CHANGE IF PRODUCTION SO INDICATES.